GAVITA PRO 630E SE CMH 930M 3000K FLOWER

The Gavita Pro 630e is available with the Philips 315W 3100° Kelvin lamps (for flowering) or 4200° Kelvin lamps (for vegetative or supplemental use). The Repeater Bus interface enables external control with the Gavita Master controllers.

Suitable for Gavita Master Controllers

Our CMH ballasts ballasts can be remote controlled by our Gavita Master Controllers. CMH lamps can not be dimmed without deterioration of the light maintenance over time, and restart problems. However, the Repeater Bus interface enables timing control and safety features with the Gavita Master controller. With this you can also integrate the fixture as a supplement light to a HPS layout.

Available with 930 Agro or 942 lamp

We recommend the 4200° Kelvin CDM Elite 942 for supplemental light and vegetative cycles. The 3100°Kelvin CDM Elite Agro 930 Agro is most suitable for generative cycles and stand-alone use. The 930 Agro has added red light in the spectrum which results in higher efficiency.

No moving parts, optimal thermal management

Our ballasts are completely sealed and passively cooled through the aluminum housing. The optimized thermal management keeps the electronics much cooler than in die-cast housings. This extremely important for the lifetime and reliability of the internal electronics.

Ideal for fixed installation

Ideal for fixed installation with brackets on Unistrut (C profile) systems, the Repeater Bus cabling system allows you to daisy-chain the fixtures in your installation. A Repeater Bus interconnect cable is included with every fixture. You can connect 5 strings of 100 fixtures per Master controller port. This enables you to control up to 1000 fixtures on one EL2 controller.

Complete fixture

The integration of ballast and reflector results in a compact fixture. No external lamp wires result in low EMI, which makes the fixture compliant with FCC regulations. All CMH fixtures are FCC tested and compliant.

Balanced fixture

The fixture is balanced, so it can be mounted by just two hanging points. This enables easy installation by brackets from C-profiles for example.

The Pro 630e CMH contains two 315W CMH lamps. We use an intelligent double ballast concept, enabling to switch off one lamp in the fixture. To make sure that both lamps have equal burning hours and to balance light on the crop, we alternate which lamp is switched off every time an autodim event occurs or when you dim down to a low level.

The fixture is equipped with the M 132 SE CMH630 reflector (medium, 132 degrees beam angle, for double CDM 315 fixtures). The medium reflector is designed for CMH only installations and will give you over 90% uniformity on your crop with an optimal horizontal penetration of the crop.

Contact your local Gavita representative or our support page for more information on recommended use and positioning of our CMH fixtures in stand alone and supplemental applications.

 Download manual